TM 11-7025-210-10
2-11. PREPARE VFU PUNCHED TAPE
INITIAL SETUP
Materials/Spare Parts
Support Equipment
VFU Opaque/Mylar Tape
VFU Punch and Splicer Device
Pen or pencil
Ruler
1.Raise cutting arm and both holddown arms as shown.
2. Mark off length of tape needed for form you will use.
NOTE
Use table 2-2 to determine information
required for punching your VFU tape.
Use a ruler or count the sprocket holes
to measure off the tape length.
3. Set tape in place on track and press onto sprockets
as shown.
2-23
