C1, TM 11-6780-225-35
each item the total quantity required for distribution and
(2) When the reference designation is
contingency planning purposes. The _.range of items
determined, scrutinize column 10b of the repair parts list
indicates the total quantities of all authorized items
(sec II).
required to provide for adequate support of 100
c. When neither the FSN nor reference designation
equipments for one year.
is known, identify the part in the illustration then
h. Depot Maintenance Allowance Per 100
scrutinize column 3 of the repair parts list.
Equipments, Column 9. This column indicates opposite
the first appearance of each item, the total quantity
B-6. Federal Supply Code for Manufacturers
authorized for depot maintenance of 100 equipments.
Code
Manufacturer
Subsequent appearances of the same item will have the
02570
Crawford Fitting Co.
letters "REF" in the allowance column. Items authorized
02660
Amphenol Corp
for use as required but not for initial stockage are
02697
Parker Seal Co.
identified with an asterisk in the allowance column.
03028
General Electric Co.
i. Illustration, Column 10.
This column is
03743
Appleton Electric Co.
divided as follows:
03296
Nylon Molding Corp
(1) Figure number, column 10a.
Indicates
04009
Arrow-Hart and Hegeman Electric Co.
the figure number of the illustration in which the item is
04034
Gems Co. Inc.
shown.
04178
General Electric Co.
(2) Item number or reference designation,
05405
Klein H. L; Mfg. Co.
column? 10ob.
Indicates the reference designation
07843
Lear Siegler Inc.
used to identify the item in the illustration.
08108
Lamp Industry
08215
Arkay Corp
B-4. Special Information
08484
Breeze Corporation Inc.
Repair parts mortality is computed from failure rates
09861
Burke and James Inc.
derived from experience factors with the individual parts
10018
Airflow Co.
in a variety of equipments. Variations in the specific
11649
Cajon Co.
application and periods of use of electronics equipment,
13680
Columbia Ribbon and Carbon Mfg. Co.
the fragility of electronic piece parts, plus intangible
Inc.
material and quality factors intrinsic to the manufacture
15235
Crouse & Hinds Co.
of electronic parts, do not permit mortality to be based on
16584
Decatur Pump Co.
hours of end item use.
However, long periods of
18163
Dale Valve Co.
continuous use under adverse conditions are likely to
18464
Crane Co.
increase repair parts mortality.
19084
Chem-Man Co.
19139
Eastman Kodak Co.
B-5. Location of Repair Parts
19220
Eberhard Mfg. Co.
a. This appendix contains one cross-reference
19804
Square D Co.
index (sec IV) to be used to locate a repair part when
24213
Consolidated Pipe Co. of America
either the Federal stock number, reference number
24455
General Electric Co.
(manufacturer's part number), or reference designation
25472
Goodrich B. F. Co.
is known. The first column in the index is prepared in
26681
Technical Corp.
numerical and/or alphanumeric sequence in ascending
27321
Honeywell Inc.
order. Where a Federal stock number is not listed, refer
27414
Grillmaster Inc.
to the reference numbers (manufacturer's part numbers)
28740
Hills McCanna Co.
immediately following the Federal stock numbers.
30057
Stonite Products Co.
b. When the Federal stock number is known, follow
30327
Imperial Division Imperial-Eastman
the procedures given in (1) and (2) below: (1) Refer to
Group I-T-E Imperial Corporation
the index of Federal stock lumbers (sec IV) and locate
33216
Kennedy Valve Mfg. Co. Inc.
the Federal stock 'number.
The FSN is cross-
39317
Me Gill Mfg. Co. Inc.
referenced to the applicable figure and reference
39428
Mc Master-Carr Supply Co.
designation.
53800
Sears Roebuck and Co.
54880
Berkey Technical Corp.
55586
S C M Corp.
56080
Sparkler Mfg Co. Inc.
61349
Ametek Inc.
B-3
