C1, TM 11-6780-225-35
APPENDIX B
DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT
MAlNTENANCE REPAIR PARTS AND SPECIAL TOOLS LIST
SECTION I. INTRODUCTION
B-1. Scope
Code
Explanation
This appendix lists repair parts and special tools required
the combat or military essentially of the end item
for the performance of direct support, general support,
dictates that a minimum quantity be available in the
and depot maintenance of the ES-82A.
supply system.
P9 - Assigned to items which are NSA design controlled:
B-2. General
unique repair parts, special tools, test, measuring
This Repair Parts and Special Tools List is divided into
and diagnostic equipment, which are stocked and
the following sections:
supplied by the Army COMSEC logistic system,
a. Repair Parts-Section II. A list of repair parts
and which are not subject to the provisions of AR
authorized for the performance of maintenance at the
380-41.
direct support, general support, and depot level.
P10 - Assigned to items which are NSA design
b. Special Tools, Test and Support Equipment-
controlled: special tools, test, measuring and
Section III. Not applicable.
diagnostic equipment for COMSEC support, which
c. Index-Federal Stock Number Cross Reference
are accountable under the provisions of AR 380-41,
to Figure and Item Number or Reference Designation--
and which are stocked and supplied by the Army
Section IV. A list of Federal stock numbers in ascending
COMSEC logistic system.
numerical sequence followed by a list of reference
M - Repair parts which are not procured or stocked, but
numbers in ascending alpha-numeric sequence, cross-
are to be manufactured in indicated maintenance
referenced to illustration figure number and reference
levels.
designation.
A - Assemblies which are not procured or stocked, as
d. Index-Reference Designation Cross Reference
such, but are made up of two or more units. Such
to Page Number-Section V. Not applicable.
component units carry individual stock numbers
and descriptions, and are procured and stocked
B-3. Explanation of Columns
separately and can be assembled to form the
The following provides an explanation of columns in the
required assembly at indicated maintenance
tabular lists.
categories.
a. Source, Maintenance, and Recoverability Codes
X - Parts and assemblies which are not procured or
(SMR), Column 1.
stocked and the mortality of which normally is
below that of the applicable end item or component.
(1) Source code, indicates the selection status
The failure of such part or assembly should result in
and source for the listed item. Source codes used are:
retirement of the end item from the supply system.
Code
Explanation
X1 - Repair parts which are not procured or stocked.
P - Repair parts which are stocked in or supplied from t
The requirement for such items will be filled by use
he GSA/DSA, or Army supply system and authorized
of the next higher assembly or component.
for use at indicated maintenance categories.
X2 - Repair parts which are not stocked. The
P2 - Repair parts which are procured and stocked for
insurance purposes because
B-1
