C2, TM 11-6780-225-12
APPENDIX D
ORGANIZATIONAL MAINTENANCE REPAIR PARTS AND
SPECIAL TOOLS LIST
Section I. INTRODUCTION
D-1. Scope
Code
Explanation
This appendix lists repair parts and special tools
P-Repair parts which are stocked in or supplied from the
required for the performance of organizational
GSA/DSA, or Army supply system and authorized
maintenance of the ES-82A.
for use at indicated maintenance categories.
D-2. General
P2-Repair parts which are procured and stocked for
This Repair Parts and Special Tools List is divided
insurance purposes because the combat or
into the following sections:
military essentiality of the end item dictates that a
minimum quantity be available in the supply
system.
a. Prescribed Load Allowance (PLA)-Section II. A
composite listing of repair parts, special tools, test and
P9-Assigned to items which are NSA design controlled:
support equipment having quantitative allowances for
unique repair parts, special tools, test, measuring
initial stockage at the organizational level.
and diagnostic equipment, which are stocked and
b. Repair Parts-Section III. A list of repair parts
supplied by the Army COMSEC logistic system
authorized for the performance of maintenance at the
and which are not subject to the provisions of AR
organizational level.
380-41.
c. Special Tools, Test and Support Equipment-
P10-Assigned to items which are NSA design controlled:
Section IV. Not applicable.
special tools, test, measuring and diagnostic
d. Index-Federal Stock Number Cross Reference
equipment for COMSEC support, which are
to Figure and Item Number or Reference Designation-
accountable under the provisions of AR 380-41,
Section V. A list of Federal stock numbers in ascending
and which are stocked and supplied by the Army
numerical sequence followed by a list of reference
COMSEC logistic system.
numbers in ascending alpha-numeric sequence, cross-
M-Repair parts which are not procured or stocked, but
referenced- to the illustration figure number and
are to be manufactured in indicated maintenance
reference designation.
levels.
e. Index-Reference Designation Cross Reference
to Page Numbers-Section VI. Not applicable.
A-Assemblies which are not procured or stocked as
such, but are made up of two or more units. Such
D-3. Explanation of Columns
component units carry individual stock numbers
and descriptions, are procured and stocked
The following provides an explanation of columns in the
separately and can be assembled to form the
tabular lists.
required assembly at indicated maintenance
a. Source, Maintenance, and Recoverability Codes
categories.
(SMR), Column 1:
X-Parts and assemblies which are not procured or
(1) Source code indicates the selection status
stocked and the mortality of which normally is
and source for the listed item. Source codes are:
below that of the applicable end item or
component. The failure of such part or assembly
should
D-1
