TM 11-6780-225-12
k. Install all protective covers.
heater exhaust cap and condensate drain plug (fig. 5-1).
l. Store all minor components, running spares,
p. Secure the space heater fresh air intake cover.
and accessories as shown in figures 1-2 through 1-8,
and 3-3.
Bolt the easels and processing rack
assemblies in position and secure all components as
the refrigerator door holding latch (fig. 5-2).
shown in figure 5-2.
r. Replace the caps on the water input, drain, and
CAUTION
dehumidifier drain connections.
Make certain that all storage drawers
are secured.
CAUTION
m. Remove the hose from the 5-gallon fuel can and
Make certain that all equipment
fuel strainer. Install the cap on the fuel can and the duet
switches and circuit breakers are set
cap on the fuel trainer (fig. 1-18).
to the OFF position 8. Replace the
n. If the darkroom is to remain mounted on a truck,
cap on the power connection.
engage the lifting rings to the eyebolts on the sides of
the truck (fig. 2-1). Tighten the turnbuckles, securing
the darkroom to the bed of the truck. To prevent the
darkroom from shifting on the truck, place blocks
it.
adjacent to each of -the four corners of the darkroom.
WARNING
Some truck models have no fender as such but the
Make certain that no personnel
wheel wells extend above the bed of the truck. On
remain
Din
darkroom
before
these trucks install cribbing both in front and in back of
performing v below.
the wheel wells to provide a flat base for the darkroom.
Make the height of the cribbing and blocking equal to
v. Secure the entrance and the escape doors, if
that of the wheel well and place suitable blocking under
necessary.
the exterior floor skids of the darkroom.
Change 5
3-5
