11-6730-235-35
APPENDIX B
DS, GS, AND DEPOT MAINTENANCE REPAIR PARTS
AND SPECIAL TOOLS
Section I. INTRODUCTION
a. Source, Maintenance, and Recoverability
B-1. Scope
Codes (SMR), Column 1.
This appendix lists repair parts and special tools
required for the performance of direct support,
(1) Source codes indicate the selection status
general support, and depot maintenance of the
and source for the listed item. Source codes used
PH-637D/PFP.
are-
Explanation
code
B-2. General
P-
Repair parts which are stocked in or supplied
This repair parts and special tools list is divided
from the GSA/DSA or Army supply system
into the following sections:
and authorized for use at indicated
maintenance categories.
Repair parts which are procured and stocked
P2-
a. Repair Parts for Direct Support, General
for insurance purposes because the combat or
Support, and Depot Maintenance - Section II. A
military essentiality of the end item dictates
list of repair parts authorized for the performance
that a minimum quantity be available in the
of maintenance at the direct support, general
supply system.
support, and depot level.
Assigned to items which are NSA design
P9-
controlled: unique repair parts, special tools,
test, measuring and diagnostic equipment,
b. Special Tools, Test and Support Equipment
which are stocked and supplied by the Army
for Direct Support, General Support, and Depot
COMSEC logistic system, and which are not
Maintenance - Section III. Not applicable.
subject to the provisions of AR 380-41.
Assigned to items which are NSA design
P10-
controlled: special tools, test, measuring and
c. Index-Federal Stock Number Cross-Reference
diagnostic equipment for COMSEC support,
to Figure and Item Number or Reference Designa-
which are accountable under the provisions of
tion - Section IV. A list of Federal Stock numbers
AR 380-41, and which are stocked and
in ascending numerical sequence followed by a list
supplied by the Army COMSEC logistic
of reference numbers in ascending alphanumeric
system.
Repair parts which are not procured or stocked,
M-
sequence, cross-referenced to figure number and
but are to be manufactured at indicated
reference designation.
maintenance levels.
Assemblies which are not procured or stocked
A-
d. Index-Reference Designation Cross-Reference
as such, but are made up of two or more
to Page Number - Section V. A list of reference
units. Such component units carry individual
stock numbers and descriptions, are procured
designations cross-referenced to page numbers.
and stocked separately, and can be assembled
to form the required assembly at indicated
B-3. Explanation of Columns
maintenance categories.
Parts and assemblies which are not procured or
x-
The following provides an explanation of columns
stocked and the mortality of which normally
is below that of the applicable end item or
in the tabular lists:
B-1
