TM 11-6720-248-12
C1
APPENDIX D
ORGANIZATIONAL MAINTENANCE
REPAIR PARTS AND SPECIAL TOOLS LIST
Code
Explanation
D-1. Scope
essentiality of the end item dictates that a
This appendix lists repair parts and special tools required
minimum quantity be available in the supply
for the performance of organizational maintenance of
system.
KS-19A4 and KS-19B.
P9-Assigned to items which are NSA design controlled:
D-2. General
unique repair parts, special tools, test, measuring
This Repair Parts and Special Tools List is divided into
and diagnostic equipment, which are stocked and
the following sections:
supplied by the Army COMSEC logistic system,
a. Prescribed Load Allowance (PLA)-Section II. A
and which are not subject to the provisions of AR
composite listing of the repair parts, special tools, test
380-41.
and support equipment having quantitative allowances
P10-Assigned to items which are NSA design controlled:
for initial stockage at the organizational level.
special tools, test, measuring and diagnostic
b. Repair Parts--Section III. A list of repair parts
equipment for COMSEC support, which are
authorized for the performance of maintenance at the
accountable under the provisions of AR 380-41,
organizational level.
and which are stocked and supplied by the Army
c. Special Tools, Test and Support Equipment -
COMSEC logistic system.
Section IV. Not applicable.
M-Repair parts which are not procured or stocked, but
d. Federal Stock Number and Reference Number
are to be manufactured in indicated maintenance
Index-Section V. A list of Federal stock numbers in
levels.
ascending numerical sequence followed by a list of
A-Assemblies which are not procured or stocked as
reference numbers in ascending alphanumeric
such, but are made up of two or more units. Such
sequence, cross-referenced to the illustration figure
component units carry individual stock numbers
number and item number.
and descriptions, are procured and stocked
e. Reference Designation Cross-Reference to
separately and can be assembled to form the
Page Number-Section VI.
A
list of reference
required assembly at indicated maintenance
designations cross-referenced to page number.
categories.
X-Parts and assemblies which are not procured or
D-3. Explanation of Columns
stocked and the mortality of which normally is
The following provides an explanation of columns in the
below that of the applicable end item or
tabular lists:
component. The failure of such part or assembly
a. Source, Maintenance, and Recoverability Codes
should result in retirement of the end item from the
(SMR), Column 1:
supply system.
(1) Source code indicates the selection status
X1-Repair parts which are not procured or stocked. The
and source for the listed item. Source codes are:
requirement for such items will be filled by use of
Code
Explanation
the next higher assembly or component.
P-Repair parts which are stocked in or supplied from the
X2-Repair parts which are not stocked. The indicated
GSA/DSA, or Army supply system and authorized
maintenance category requiring such repair parts
for use at indicated maintenance categories.
will
attempt
to
obtain
same
through
P2-Repair parts which are procured and stocked for
cannibalization. Where such repair parts are not
insurance purposes because the combat or
obtainable through cannibalization, requirements
military
will be requisitioned,
with
accompanying
justification, through normal supply channels.
G-Major assemblies that are procured with PEMA funds
for initial issue only as exchange assemblies at
DSU and GSU levels. These assemblies will not
be stocked above DS and GS level or returned to
depot supply level.
(2) Maintenance code indicates the lowest
category of maintenance authorized to install the listed
item. The maintenance level codes are:
Code
Explanation
C
Operator/Crew
O
Organizational Maintenance
D-1
