service cord containing two stranded wire conductors. On one end is a
molded male connector and on the other is a molded female connector.
6. Technical Characteristics
Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..Opaque object
Projection lamp . . . . . . . . . . . . . . . . . . . . . . . . .1,000-watt, 115-volt, T-20 medium
prefocus, C13 filament.
Projected image . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. From 34 by 34 in. at 7.5 ft. to
120 by 120 in. at 22 ft. (using
10 by 10 in. aperture) .
Fan motor . . . . . . . . . . . . . . . . . . . . . . . . . 115-volt ac, 60-cycle, single phase,
open construction, shaded pole.
Power supply . . . . . . . . . . . . .. . . . . . . . . 115.volt ac, 60-cycle.
Projection lens . . . . . . . . . . . . . . . . 22 in. effective focal length,
41
in. dia.
7. Additional Equipment Required
A projection screen is required. Any type of semimatte screen may
be used. A flat, light-colored wall surface will give fair results if no
screen is available.
8. Packaging and Packing Data
Still Picture Projector AP-5 (1) with its components and accessories
are placed within the designated compartments in the carrying case
four fastenings. The carrying case is cushioned at each corner and at
the top and bottom with fiberboard inserts and is placed within a
waterproof, fiberboard carton. The entire closure is sealed with water-
proof tape. The packaged equipment is placed within a second corru-
gated carton and sealed with gummed tape.
7
