TM 10-3610-202-14
Figure 9-2. Immersion Heater Control
(3) If water temperature cannot be maintained at
approximately 82 degrees F (28 degrees C), replace
immersion heater.
d. Installation. Install the immersion heater as
follows:
(1) If necessary, remove any temporary cover
from immersion heater hole in tank.
(2) Install heater into tank and using a suitable
wrench, tighten to correct position.
(3) Close faucet and draincock.
(4) Fill tank with approximately 10 gallons (37.8
liters) of water.
(5) Connect immersion heater power cord to
heater receptacle.
9-4
