TM 5-4940-228-14
APPENDIX B
COMPONENTS OF END ITEMS LIST
Section I.
I N T R O D U C T I O N
B-1. Scope.
This appendix lists Integral Components of and Basic Issue Items (BII) for the Paint Spray Outfit to help
you inventory items required for safe and efficient operation.
B-2. General.
The components of end item list are divided into the following sections:
a. Section II. Integral Components of the End Item. These items, when assembled, comprise the Paint
Spray Outfit and must accompany it whenever it is transferred or turned in. These illustrations will help you
identify these items.
b. Basic Issue Items. These are minimum essential items required to place the Paint Spray Outfit in oper-
ation, to operate it and to perform emergency repairs. Although shipped separately packed they must accom-
pany the Paint Spray Outfit during operation and whenever it is transferred between accountable officers.
The illustrations will assist you with hard-to-identify items. This manual is your authority to requisition re-
placement BII baaed on Table(s) of Organization and Equipment (TOE) /Modification Table of Organization
and Equipment (MTOE) authorization of the end item.
B-3. Explanation of Columns.
a. Illustration. This column is divided as follows:
(1) Figure Number. Indicates the figure number of the illustration on which the item is shown (if ap-
plicable).
(2) Item Number. The number used to identify item called out in the illustration.
b. National Stock Number (NSN). Indicates the national stack number assigned to the end item which
will be used for requisitioning.
c. Part Number (P/N). Indicates the primary number used by the manufacturer which controls the design
and characteristics of the item by means of its engineering drawings, specifications, standards and inspection
requirements to identify an item or range of items.
d. Description. Indicates the federal item name and, if required, a minimum description to identify the
item.
e. Location. The physical location of each item listed is given in this column. The lists are designed to in-
ventory all items in one area of the major item before moving on to an adjacent area.
f. Usable on Code. “USABLE ON” codes are included to help you identify which component items are
used on the different models. Identification of the codes used in the list are:
Code
Used On
g. Quantity Required (Qty Reqd). This column lists the quantity of each item required for a complete
major item.
h. Quantity. This column lists the quantity you actually receive on your major item. The date columns
are for use when you inventory the major item at a later date, such as for shipment to another site.
B-1
