TM 5-4940-228-14
CHAPTER 5
DIRECT SUPPORT AND GENERAL SUPPORT
MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
5-1. No special tools or equipment are required for
parts manual TM 5-4940-228-24P.
maintenance of this Paint Spray Outfit.
5-3. No special fabricated tools or equipment are
5-2. Repair parts are listed and illustrated in repair
required.
Section II. TROUBLESHOOTING
5-4. General.
a. This section contains troubleshooting infor-
mation for locating and correcting most of the oper-
ation troubles which may develop in the Paint
Spray Outfit. Each malfunction for an individual
component, unit, or system, is followed by a list of
tests or inspections which will help you to deter-
mine corrective actions to take. You should perform
the tests/inspections and corrective actions in the
order listed.
b. This manual cannot list all malfunctions
which may occur, nor all tests or inspections and
corrective actions. If a malfunction is not listed, or
is not corrected by listed corrective actions, notify
your supervisor.
5-5. Troubleshooting Table.
NOTE
Before you use thin table, be sure you
have performed all applicable oper-
ating checks.
Section III. GENERAL MAINTENANCE
5-6. General.
5-7. General Disassembly Procedures.
Refer to Chapters 2, 3 and 4 for operator mainte-
a. Components to be repaired shall be disassem-
nance checks and services for the Paint Spray
bled to the extent required for complete ser-
Outfit.
viceability.
b. Serviceable and precision parts should be han-
dled, marked and stored to prevent damage and
allow for reassembly after repairs are made.
Section IV. REMOVAL AND INSTALLATION OF MAJOR COMPONENTS
5-8. General.
(70) at compressor side first.
This section covers removal and installation of
b. Remove fuel line (12) from engine and fuel
all major assemblies of the compressor, cart moun-
line clamp at engine rear bracket (16).
ted. Figure 5-1 illustrates the disassembly of the
complete compressor assembly.
c. Remove four each engine mounting nuts (5),
washers (6) and bolts (7).
5-9. Removal of Engine (Fig. 5-1).
d. Slide engine (21) towards compressor and re-
move two belts (8).
a Remove belt guard (4) by removing four nuts
(1) and two bolts (2). Lift belt guard off platform
e. Engine (21) is now free and can be lifted from
platform (70).
5-1
