TM 5-3610-295-13&P-1
3-3. GENERAL. - Continued
Table 3-1. Operator Troubleshooting - Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
7. PMT PROCESSOR FILM OR PAPER FAILS TO TRANSPORT.
Step 1. Film or paper pileup or jamming.
Clear processor of remaining material and refer to manufacturer's manual for further instructions.
8. PIN-POINT LIGHT SOURCE WON'T WORK.
Step 1. Light source not plugged in.
Plug light source in.
Step 2. Timer not set.
Set timer.
Step 3. Lamp burned out.
Replace lamp.
9. WALL MOUNTED VIEWING LIGHT WILL NOT OPERATE.
Step 1. Check if light source is plugged in.
Plug in light source.
Step 2. Check for loose or burned out fluorescent tube.
Tighten or replace fluorescent tube.
Step 3. Check for loose or burned out starter.
Tighten or replace starter in accordance with paragraph 4-27.
3-6