TM 5-3610-293-13&P
2-15. PREPARATION FOR MOVEMENT.
WARNING
Never connect or disconnect any power cables when electrical power is energized
to the cables. Failure to do so will result in damage to equipment and/or serious
injury or DEATH to personnel.
a.
Place all ON/OFF power switches on all operating equipment in the shelter in the OFF position.
b.
Place all circuit breakers and switches on the Power Distribution Panel in the shelter in the OFF position.
c.
Notify Module C operator that you are ready for the main circuit breaker CB1 on the Power Distribution Box to be
put in the OFF position. Wait until Module C operator has put the Power Distribution Box main circuit breaker CB1 in the
OFF position before performing step d.
d.
Disconnect power cable between the Power Distribution Box and the Press Section shelter. Roll power cable and
place in storage compartment behind cargo doors under AC units. Disconnect grounding rod wire, remove grounding
rod, and stow in storage rack.
e.
Drain lubricating oil from side covers of printing press (Refer to TM 5-4210-304-10). Spray unpainted surfaces
with lubricant (Appendix E, item 22). Place cover on printing press.
f.
Return all tools, and materials and other small items to their proper storage locations.
g.
Secure all cabinet and storage compartment doors.
h.
Unplug electrical cords of the ceiling fluorescent light assemblies in the expanded sections of the shelter.
Remove light assemblies by depressing the safety release button, sliding the light assemblies in their overhead storage
locations in the center section of the shelter and secure their electrical cords in their storage clips. Secure light
assemblies with safety release brackets.
NOTE
Each equipment item to be stowed in the shelter center section is marked with a
colored dot. There is a corresponding colored dot on the shelter ceiling and
floors. Items are to be stored in the order listed below by matching the colored
dot on the equipment with its matching colored dot in the floor and ceiling of the
shelter center section.
2-40
