SECTION I.
INTRODUCTION
Code
Explanation
1-1. Scope
This manual lists repair parts and special tools required
stocked only for subsequent or additional
for the performance of organizational maintenance of the
initial issues or outfittings. Not subject to
EK-1 (1), EK-1 (2), EK-1 (3), EK-1 (4), and PH-240-B.
automatic replenishment.
The PCCN for the equipment is GRNACO for all models.
PE - Support equipment procured and stocked for
1-2. General
tenance repair activities.
PF - Support equipment which will not be stocked
This repair parts and special tools list is divided into the
but which will be centrally procured on
following sections:
demand.
a. Prescribed Loan Allowance (PLA) -Section II. Not
PG - Item procured and stocked to provide for
applicable.
sustained support for the life of the
b Repair Parts Lists-Section III. A list of repair parts
equipment. It is applied to an item
authorized for the performance of maintenance at the
peculiar to the equipment which because
organizational level. This repair parts list is arranged in
of probable discontinuance or shutdown of
alphabetical order.
production facilities would prove un-
c. Special Tools, Test and Support Equipment -
economical to reproduce at a later time.
Section IV. Not applicable.
KD - An item of depot overhaul/repair kit and not
d. Index - Federal Stock Number and Reference
purchased separately. Depot kit defined
Number Cross-Reference to Figure and Item Number -
as a kit that provides items required at the
Section V. A list, in ascending numerical sequence, of all
time of overhaul or repair.
Federal stock numbers appearing in the listings, followed
KF - An item of a maintenance kit and not
by a list, in alphanumeric sequence, of all reference
purchased separately. Maintenance kit
numbers appearing in the listings. Federal stock number
defined as a kit that provides an item that
and reference numbers are cross-referenced to each
can be replaced at organizational or direct
illustration figure and item number or reference
support or general support levels of
designation appearance.
maintenance.
KB - Item included in both a depot over-
1-3. Explanation of Columns
haul/repair kit and a maintenance kit.
MO - Item to be manufactured or fabricated at
The following provides an explanation of columns in the
organizational level.
tabular lists:
MF - Item to be manufactured or fabricated at
a. Source, Maintenance, and Recoverability Codes
direct support maintenance level.
(SMR).
MH - Item to be manufactured or fabricated at
(1) Source code. Indicates the manner of acquir-
general support maintenance level.
ing support items for maintenance, repair, or
MD - Item to be manufactured or fabricated at
overhaul of end items. Source codes are:
depot maintenance level.
AO - Item to be assembled at organizational level.
Code
Explanation
AF - Item to be assembled at direct support
maintenance level.
PA - Item procured and stocked for anticipated or
AH - Item to be assembled at general support
known usage.
maintenance level.
AD - Item to be assembled at depot maintenance
purposes because essentiality dictates
level.
that a minimum quantity be available in
XA - Item is not procured or stocked because the
the supply systems.
requirements for the item will result in
PC - Item procured and stocked and which
the replacement of the next higher as-
otherwise would be coded PA except that
sembly.
it is deteriorative in nature.
XB - Item is not procured or stocked. If not
PD - Support item, excluding support equipment,
2