TM 11-6720-242-35
APPENDIX B
DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT
MAINTENANCE REPAIR PARTS
AND SPECIAL TOOLS LIST
Section I. INTRODUCTION
B-1. Scope
(1) Source code indicates the selection status and
source for the listed item. Source codes are:
his appendix lists repair parts, special tools and test
Code
Explanation
equipment required for the performance of direct
P - Repair parts which are stocked in or supplied from
support, general support, and depot maintenance of
the GS/DSA, or Army supply system, and
Camera, Still Picture KA-60C.
authorized for the use at indicated maintenance
B-2. General
categories.
P2 - Repair parts which are procured and stocked for
This Repair Parts and Special Tools List is divided into
insurance purposes because the combat or
the following sections:
military essentially of the end item dictates that
a. Repair Parts for Direct Support, General
a minimum quantity be available in the supply
Support, and Depot Maintenance-Section II. A list of
system.
P9 - Assigned to items which are NSA design controlled:
repair parts authorized for the performance of
unique repair parts, special tools, test,
maintenance at the direct support, general support, and
measuring and diagnostic equipment, which are
depot level.
stocked and supplied by the Army COMSEC
b. Special Tools, Test and Support Equipment
provisions of AR 380-41.
Section III. A list of special tools, test, and support
P10 - Assigned to items which are NSA design
controlled special tools, test, measuring and
equipment authorized for the performance of
diagnostic equipment for COMSEC support,
maintenance at the direct support, general support, and
which are accountable under the provisions of
depot level.
AR 380-41, and which are stocked and supplied
c. Index-Federal Stock Number and Reference
by the Army COMSEC logistic system.
M - Repair parts which are not procured or stocked but
Number Cross Reference to Figure and Item Number or
are to be manufactured at indicated
Reference Designation-Section IV. A list of Federal
maintenance levels.
stock numbers in ascending numerical sequence,
A - Assemblies which are not procured or stocked as
followed by a list of reference numbers in ascending
such, but are made up of two or more units.
alphanumeric sequence, cross-referenced to the
Such component units carry individual stock
illustration figure number and reference designation.
numbers and descriptions, are procured and
stocked separately and can be assembled to
d. Index-Reference Designation Cross Reference
form the required assembly at indicated
to Page Number-Section V.
A list of reference
maintenance categories.
designations cross-referenced to page numbers.
X - Parts and assemblies which are not procured or
stocked and the mortality of which normally is
B-3. Explanation of Columns
below that of the applicable end item or
The following provides an explanation of columns in the
component.
tabular lists:
a. Source, Maintenance, and Recoverability Codes
(SMR), Column 1:
Change 2 B-1
