TM 10-3610-203-14
Figure 4-9. Tool Board Assembly, Removal and Installation.
(2)
Carefully remove the plunger can, ensuring that any solvent in the can is not spilled.
(3)
Remove the self-tapping screws which attach the plunger can holder mount to the tool board and remove
the holder.
(4)
Remove the screws, flat washers and lock-washers which attach the tool board to the shelter wall and
remove the board.
c.
Installation. Install the replacement tool board assembly as follows:
(1)
Using heavy paper construct a mounting hole location template by placing the paper on the removed tool
board and marking mounting holes.
NOTE
Ensure mounting holes for the plunger can are included in the template.
(2)
Using the template as a pattern, drill mounting holes in the replacement tool board,
(3)
Position the tool board in the correct location on the shelter wall and install the attaching
screws, flat washers and lockwashers.
(4)
Position the dispenser can mount on the tool board so that the holes in the mount align with the marks
previously made on the board, and install the attaching self-tapping screws.
(5)
Position dispenser can in holder mount and install attaching worm drive clamp.
Section X. MAINTENANCE OF LADDER
4-22. General
A steel ladder, used to gain entry to the shelter when truck mounted, is located on the left shelter wall just forward of
the duplicating machine. Two metal clamps are attached to the upper end of the ladder and are used for securing the
ladder while in use. (See fig. 4-10.)
4-26
