TM 10-3610-202-14
Table 4-2. Troubleshooting (Con't)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
SHELTER SYSTEM COMPONENTS (Con't)
b. Remove the composing machine.
c. Remove the screws which attach the mounts on the replacement composer and remove the mounts.
d. Position the replacement composing machine over the four mounting holes in the stand assembly top.
e. Insert and finger tighten the four attach bolts from the underside of the stand assembly top.
f. Tighten the four attach bolts with a socket wrench.
2. NO WATER AT FAUCET.
Step 1. Inspect for lack of water In storage tank.
If necessary, fill water storage tank as follows:
CAUTION
Do not operate immersion heater when water tank is empty.
a. Check that all valves in the water line are closed.
b. Remove the tank filler cap located on the roof of the shelter.
c. Fill the tank to its full capacity of approximately 10 gallons (37.8 liters) with clean water, and replace the
filler cap.
d. Open the humidifier supply valve (see fig. 4-4) allowing the humidifier water tank to fill to its preset level.
4-18
