MAINTENANCE ALLOCATION CHART
SECTION I. INTRODUCTION
a. This section provides a general explanation of all maintenance and repair functions authorized at various
b. The Maintenance Allocation Chart (MAC) in Section II designates overall responsibility for the performance of
maintenance functions on the identified end item or component. The implementation of the maintenance functions upon
the end item or component will be consistent with the assigned maintenance functions.
c. Section III lists the special tools and test equipment required for each maintenance function as referenced from
d. Section IV contains supplemental instructions or explanatory notes for a particular maintenance function.
a. Inspect. To determine the serviceability of an item by comparing its physical, mechanical, and/or electrical
characteristics with established standards through examination.
Test. To verify serviceability and detect incipient failure by measuring the mechanical or electrical
characteristics of an item and comparing those characteristics with prescribed standards.
Service. Operations required periodically to keep an item in proper operating condition, i.e., to clean
(decontaminate), to preserve, to drain, to paint, or to replenish fuel, lubricants, hydraulic fluids, or compressed air
d. Adjust. To maintain, within prescribed limits, by bringing into proper or exact position or by setting the operating
characteristics to specified parameters.
e. Align. To adjust specified variable elements of an item to bring about optimum or desired performance.
Calibrate. To determine and cause corrections to be made or to be adjusted on instruments or test measuring
and diagnostic equipments used in precision measurement. Consists of comparisons of two instruments, one of which is
a certified standard of known accuracy, to detect and adjust any discrepancy in the accuracy of the instrument being