4-22. RUB-UP BOARD AND MOUNTING ASSEMBLY. - Continued
c. Repair. - Continued
If damaged, replace rubber pad.
Remove rubber pad (1) from rub-up board (2) with putty knife.
DEATH or serious injury could result by repeated and/or prolonged
breathing and/or liquid skin contact of dry cleaning solvent P-D680. Use in
a well-ventilated area. Do not use near open flame or in excessive heat.
The flash point of this solvent is 100F 138F (38C - 59C).
Remove adhesive from rub-up board. Use drycleaning solvent (Appendix E, item 17.)
Allow the cementing compound sufficient time to dry (at least 48 Hours)
before cleaning the rub-up board assembly.
Apply adhesive (Appendix E, item 2) to rubber pad (1).
Position rubber pad (1) on rub-up board (2).