MAINTENANCE ALLOCATION CHART
Section I. INTRODUCTION
This section provides a general explanation of all maintenance and repair functions authorized at various
Section II designates overall responsibility for the performance of maintenance functions on the identified end
item or component and the work measurement time required to perform the functions by the designated maintenance
level. The implementation of the maintenance functions upon the end item or component will be consistent with the
assigned maintenance functions.
Section III lists the tools and test equipment required for each maintenance function as referenced from
B-2. EXPLANATION OF COLUMNS IN SECTION II.
Column 1. Group Number. Column 1 lists group numbers to identify related components, assemblies,
subassemblies, and modules with their next higher assembly. The applicable groups are listed in the MAC in
disassembly sequence beginning with the first group removed.
Column 2, Component/Assembly. This column contains the noun names of components, assemblies,
subassemblies and modules for which maintenance is authorized.
Column 3, Maintenance Functions. This column lists the functions to be performed on the item listed in
Column 2. The maintenance functions are defined as follows:
(1) Inspect. To determine serviceability of an item by comparing its physical, mechanical, and/or
electrical characteristics with established standards through examination.
(2) Test. To verify serviceability and detect incipient failure by measuring the mechanical or electrical
characteristics of an item and comparing those characteristics with prescribed standards.