TM 11-7025-210-23
4-29. REMOVE/REPLACE FRONT COOLING FAN (CONT)
5. Using 1/4 in.
open end wrench, remove fourth
screw.
6. Pull out fan.
Replace
1. Position fan.
2. Replace four screws and washers.
3. Connect connector.
4. Tighten screw on cable clamp.
9).
6. Close cover. Install paper.
CAUTION
Be sure all wires are away from fan blades before
powering on.
7. Power on printer.
8. Hold hand near fan. Make sure air flows into printer.
4-60