number of task-hours specified by the "work time" figure
Tool and Test Equipment Requirements
represents the average time required to restore an item
(assembly, subassembly, component, module, end item
or system) to a serviceable condition under typical field
a. Tool or Test Equipment Code. The numbers in
operating conditions. This time includes preparation
this column coincide with the numbers used in the tools
time, troubleshooting time, and quality assurance/quality
and equipment column of the MAC. The numbers
control time in addition to the time required to perform
indicate the applicable tool or test equipment for the
the specific tasks identified for the maintenance
functions authorized in the maintenance allocation chart.
b. Maintenance Category.
The codes in this
Subcolumns of column 4 are as follows:
column indicate the maintenance category allocated the
tool or test equipment.
c. Nomenclature. This column lists the noun name
C - Operator/Crew
and nomenclature of the tools and test equipment
O - Organizational
required to perform the maintenance functions.
F - Direct Support
d. National/NATO Stock Number. This column lists
H - General Support
the National/NATO stock number of the specific tool or
D - Depot
e. Tool Number.
This column lists the
e. Column 5, Tools and Equipment. Column 5
manufacturer's part number of the tool followed by the
specifies by code, those common tool sets (not individual
Federal Supply Code for manufacturers (5-digt) in
tools) and special tools, test, and support equipment
required to perform the designated function.
Remarks (sec IV)
Column 6, Remarks. Column 6 contains an
a. Reference Code.
This code refers to the
alphabetic code which leads to the remark in section IV,
appropriate item in section II, column 6.
Remarks, which is pertinent to the item opposite the
b. Remarks. This column provides the required
explanatory information necessary to clarify items
appearing in section II.
Change 2 C-2