clean piece of crumpled lens tissue. If foreign matter
still remains, moisten a piece of lens tissue with lens
cleaner and wipe the surface. Remove any moisture
with a fresh piece of lens tissue.
(b) Rear surface. Clean the rear surface as
described in (a) above.
(c) Everready case. Wipe down the interior
and exterior surfaces with a clean, lint-free cloth. Re-
move dirt from around the snaps. Blow dust from in-
side the case. If necessary, the exterior of the case may
be cleaned with a damp cloth and mild soap. Remove
all soap with a clean damp cloth.
a. Charging Battery.
NOTE
Charge the flash unit battery before and after each
it takes more than 30 sec for the ready light (fig.
2-3) to
come on
again after
flashing.
(1) Insure that the battery ON-OFF switch on
the flash unit is set at OFF.
(2) Insure that the AC/charge unit VOLTAGE
SELECTOR IS SET FOR THE AC line voltage
available.
(3) Plug the AC/charge unit into an AC recep-
tacle.
( 4 ) Connect the AC/charge unit cord to the
flash unit.