This manual lists spares and repair parts; special tools;
Cannibalization or salvage may be
special test, measurement, and diagnostic equipment
used as a source of supply for any
(TMDE), and other special support equipment required
items source coded above except
for performance of direct support, and general support
those coded XA and aircraft support
maintenance of the KA-60C.
It authorizes the
items as restricted by AR 700-42.
requisitioning and issue of spares and repair parts as
(2) Maintenance code. Maintenance codes
indicated by the source and maintenance codes.
are assigned to indicate the levels of maintenance
authorized to USE and REPAIR support items. The
maintenance codes are entered in the third and fourth
This Repair Parts and Special Tools List is divided into
positions of the Uniform SMR Code format as follows:
the following sections:
(a) The maintenance code entered in
the third position will indicate the lowest maintenance
and repair parts authorized for use in the performance of
level authorized to remove, replace, and use the support
maintenance. The list also includes parts which must be
item. The maintenance code entered in the third
removed for replacement of the authorized parts. Parts
position will indicate one of the following levels of
lists are composed of functional groups in numeric
sequence, with the parts in each group listed in figure
and item number sequence.
0 -Support item is removed, replaced, used at the
b. Section III. Special Tools List. Not applicable.
F -Support item is removed, replaced, used at the
direct support level.
Number Index. A list, in National item identification
H -Support item is removed, replaced, used at the
number (NIIN) sequence, of all National stock numbers
general support level.
(NSN) appearing in the listings, followed by a list, in
(b) The maintenance code entered in
alphameric sequence, of all part numbers appearing in
the fourth position indicates whether the item is to be
the listings. National stock numbers and part numbers
repaired and identifies the lowest maintenance level
are cross-referenced to each illustration figure and item
with the capability to perform complete repair (i.e., all
authorized maintenance functions). This position will
3. Explanation of Columns
contain one of the following maintenance codes:
a. Illustration. This column is divided as follows:
(1) Figure number.
Indicates the figure
F -The lowest maintenance level capable of com-
number of the illustration on which the item is shown.
plete repair of the support item is the direct
(2) Item number.
The number used to
identify item called out in the illustration.
H -The lowest maintenance level capable of com-
b. Source, Maintenance, and Recoverability (SMR)
plete repair of the support item is the general
Z -Nonreparable. No repair is authorized.
(1) Source code. Source codes indicate the
(3) Recoverability code.
manner of acquiring support items for maintenance,
codes are assigned to support items to indicate the
repair, or overhaul of end items. Source codes are
disposition action on unserviceable items.
entered in the first and second positions of the Uniform
recoverability code is entered in the fifth position of the
SMR Code format as follows:
Uniform SMR Code format as follows:
PA-Item procured and stocked for anticipated or
Z -Nonreparable item. When unserviceable, con-
PD-Support item, excluding support equipment,
demn and dispose at the level indicated in posi-
stocked only for subsequent or additional in-
F -Reparable item. When uneconomically reparable,
condemn and dispose at the direct support
XD-A support item that is not stocked. When re-
H -Reparable item When uneconomically reparable,
quired, item will be procured through normal
condemn and dispose at the general support