Add appendix IV:
APPENDIX IV (Added)
ORGANIZATIONAL, DIRECT AND GENERAL
SUPPORT AND DEPOT
MAINTENANCE REPAIR PARTS LIST
Section I. INTRODUCTION
1. General
a. This manual includes an organizational, direct and general support,
and depot maintenance special tool list.
(1) The organizational maintenance repair parts and special tool
list lists the quantities of repair parts authorized for organiza-
tional maintenance and is a basis for requisitioning by organi-
zations which are authorized the major item of equipment.
End items of equipments are issued on the basis of allowances
prescribed in equipment authorization tables and other docu-
ments that are a basis for requisitioning.
(2) Direct and general support and depot maintenance repair parts
and special tool list shows the quantities of repair parts author-
ized for direct and general support maintenance and is a basis
for requsitioning authorized parts. It is also a guide for depot
maintenance in establishing initial levels of spare parts.
b. Columns are as follows:
(1) Source, maintenance, and recoverability code. Source, mainte-
nance, and recoverability codes indicate the commodity com-
mand responsible for supply, the maintenance category
at
which an item is stocked, categories at which an item is installed
or repaired, and whether an item is repairable or salvageable.
The source code column is divided into four parts.
(a) Column A. This column indicates the materiel code and
designates the area of responsibility for supply. AR 310-1
defines the basic numbers used to identify the materiel code.
If the part is Signa1 materiel responsibility, the column is
left blank.
(b) Column B. This column indicates the point within the main-
tenence system where the part is available. "X2"-applies
to repair parts which are not stocked. The indicated main-
tenance category requiring such repair parts will attempt to
obtain from salvage; if not obtainable from salvage, such
through normal supply channels.
16
TAGO 7114-B